Hall Research UV8-S - Manual (Page 7)

4 or 8 Channel Splitter PC Video & Power over Twisted-Pair Sender
5
2.2 Cable Requirements
All units can use with CAT5/5e/6 or Zero-Skew™ UTP or STP (unshielded or
shielded twisted pair) cables. Low-skew UTP cable (such as Hall Research’s Zero-
skew™ CAT5 cable) is recommended particularly if cable lengths are 200 feet or
longer.
IMPORTANT
Do not connect this unit to any LAN device such as network cards or hubs as this may cause
damage. Use EIA/TIA 568B standard straight-through patch wiring as shown below. Do not use
crossover cables.
EIA/TIA 568B WIRING STANDARD
PIN Wire Color
1 White w/ Orange Stripe
2 Orange
3
White w/Green Stripe
4 Blue
5
White w/Blue Stripe
6 Green
7
White w/Brown Stripe
8 Brown
3. Configuration & Operation
The table below lists the recommended maximum distances from sender to the
receiver depending on the resolution used.
Refresh Rate
60 Hz 75 Hz
800x600 500 ft 500 ft
1024x768 500 ft 500 ft
1280x1024 500 ft 500 ft
Resolution
1920x1200 500 ft 500 ft
There are no user adjustments on the UV4-S or UV8-S.
Use the included screwdriver to adjust the compensation pots on the Model UV1-R
receiver for the best picture quality.
Table 1 -
Recommended
maximum CATx cable
length from sender to
the receiver
Figure 2