Hall Research UU-2X4 - Manual (Page 6)

Dual-Channel USB-Over-Cat5 Extender
4
2. Installation
2.1 Setup
1. Power down the PC.
2. Place the Sender (also referred to as Local or Transmitter) unit near the host
computer.
3. Plug the supplied power adapter into an AC outlet and connect it to the Sender.
4. Plug one or both Type B connectors on the extender using the included cable into
the PC.
5. At the remote location plug the supplied power adapter into the Receiver.
6. Using Cat6 or Cat5e cable, connect the Sender to the Receiver.
7. Power up the PC.
8. The PC will recognize the extender as Hubs and automatically installs them.
9. Plug the USB devices to the receiver unit. As you do this, the PC will recognize
each device and if it has default drivers for them they will automatically get installed;
or if you have a custom driver supplied with the device, you may have to install that
driver just as you would if you had plugged the device directly to the PC.
Figure 1. Sender (bottom) & Receiver (top) connectors and indicators