Hall Research UH-2C-S-DP - Manual (Page 4)

2
HDMI™
Re-clocking Extender
1.2 Features
Use Cat5e or Cat6 cables to extend pure digital high definition HDMI™ audio video signals
Can drive cables to 200 ft @ 1080i/720P or 150ft @ 1080p on 2 Cat6 cables
Supports DVI-D single link extension with optional adapter cables
Only one power supply needed for the setup
Re-aligns the pixel clock and generates a clean pixel clock for the display
HDCP compliant
Daisy-chainable to achieve longer distances
Compact metal enclosure measuring 3.25 x 1.75 x 0.85 inch
Includes a universal power supply
2. Installation
Refer to figure 1 above. Place the sender by the video source. Use a quality HDMI™ cable to
connect the source to the sender (the cable is not included and must be purchased separately).
Use (2) Cat6 cables to connect the sender to the receiver. Make sure to not cross the connections
as this may cause damage to the unit or the power supply. The RJ45 outputs are labeled as 1 and
2, please label the ends of your UTP cable so that it is easy to plug the ends correctly.
Turn on the display and the video source and plug in the power supply (included) into the receiver.
† For HDMI™ compliance, if the input has HDCP content protection, the display must also be
HDCP compliant (such as a display with HDMI™ input) otherwise no image will be shown on the
display.
TRADEMARKS USED IN THIS MANUAL
Hall Research and the Hall Research Logo ( ) are trademarks of Hall Research.
HDMI™ is a registered trademark of HDMI Licensing LLC
Any other trademarks mentioned in this manual are acknowledged to be the property of the
trademark owners.