Hall Research UH-1C - Manual (Page 4)

2
HDMI™ Re-clocking Extender
1.2 Features
Use Cat5e or Cat6 cables to extend pure digital high definition HDMI™ audio video signals
Can drive cables to 200ft @ 1080i/720P or 150ft @ 1080p on 1 Cat6 cable
Supports DVI-D single link extension with optional adapter cables
Two power supplies needed for the setup
Re-aligns the pixel clock and generates a clean pixel clock for the display
HDCP compliant
Daisy-chainable to achieve longer distances
Compact metal enclosure measuring 4.625 x 2.75 x 1.25 inch with mounting flanges
Includes universal power supplies
2. Installation
Refer to figure 1 above. Place the sender by the video source. Use a quality HDMI™ cable to
connect the source to the sender (the cable is not included and must be purchased separately).
Use 1 Cat6 cable to connect the sender to the receiver observing the length limitations. Connect
the cable to the receivers RJ45 output and finally using a quality HDMI™ cable; connect the
receiver to the output display device.
Turn on the display and the video source and plug in the power supplies (included) into both the
sender and receiver.
† For HDMI™ compliance, if the input has HDCP content protection, the display must also be
HDCP compliant (such as a display with HDMI™ input) otherwise no image will be shown on the
display.
TRADEMARKS USED IN THIS MANUAL
Hall Research and HR (logo) are trademarks of Hall Research Technologies Inc. HDMI™ is a
registered trademark of HDMI Licensing LLC
Any other trademarks mentioned in this manual are acknowledged to be the property of the
trademark owners.