Gryphon Antileon Signature Mono - Manual (Page 14)

which incorporates a special
epoxy resin to optimise trans-
former vibration damping.
The faceplate is machined from
a solid 40 mm black acrylic
block. An LED display provides
continuous information on Class
A status and AC condition.
With the exception of the face-
plate, the Antileon exterior con-
sists entirely of brushed, black
anodized alluminium. Allen
screws are countersunk for
clean appearance.
Installation
Unpacking
Obviously, the purpose of pack-
ing materials in the transporta-
tion of heavy amplifiers is to pro-
tect the product on its perilous
journey from manufacturer to
proud owner.
Unfortunately, in our experience
this often results in sprained
backs and bleeding fingers at
the moment of truth: the uncrat-
ing of hefty power amplifier.
The instructions found on top of
the box you will find instructions
and illustrations for disassemble
and assembling the transporta-
tion box.
The cases can be completely
dismantled for easy storage.
Keep the boxes and all the parts
in a dry place
The following items are
enclosed:
2 Antileon Signature mono´s
1 Pair of gloves
1 Acrylic polish
2 XLR adaptors
2 AC power cords
1 Warranty card
If anything is missing or dam-
aged, please contact your
Gryphon dealer immediately.
AC Power
VERY IMPORTANT
Before installation, you must
ensure that sufficient current is
available from you domestic AC
power supply:
Minimum: 10A for 220/240 V
Minimum: 20A for 100/120 V
It is also very important that the
wiring from your AC breaker can
carry the high constant AC volt-
age with only a minimum of loss.
A conductor with a minimum
gauge of 1.5 sq. mm. Is recom-
mended.
The Antileon should ideally be
connected to a separate AC
breaker group independent of
other equipment.
Placement
The Antileon is a high bias Class
A design and
MUST be placed
so that air may circulate freely
around the heatsinks. The
14