Grandview LF-MIRCI(Recessed-Ceiling Series) - Manual (Page 2)

1
Product Specifications
14
(1) For adjusting the viewing area, please insert the adjustment to regulate adjustment hole. A
clockwise adjustment will increase the viewing area for about 13mm.
Note: After pressing the up button, you will need a few seconds to see the adjustment of screen;
and after pressing the down button, you will see the position changed of screen.
Please do not operate the following step before step1 to avoid damages of screen.
(2) A counterclockwise cycle can adjust the distance to 13mm between casing and rod.
Please be careful while operating, too much retracting will cause the damages of screen and motor.
Note:
1. Due to product updates, sizes and specifications are subject to change at any time.
The tolerance for L is approximately ± 5mm (3/16 inches).
2. Actual dimension is measured by: total screen length L x end cap depth x end cap height.
B1
B
2
H
W
170
A
B
3
L
1
6
1
B1
Caution
by inappropriate installation or operation.
2. Please keep the screen away from hot sources, such as radiator, heating machine, fireplace,
loudspeaker or other relative device.
3. Only Plug with ground wire is acceptable.
4. Only accessories from authorized supplier is acceptable.
5. Please unplug the power wire when lighting and raining or not use with a long time.
6. Please handle the repair work to the professional agent.
7. Please prevent screen from wet and water .
8. As soon as the plug of the screen is connected to the power source, the screen is connecting
with electricity.
9. Please use the approved power line (three-core power line)/ device interface/power plug.
10. Please use the rating (voltage, amps) power line (three-core power line) / device interface/power
plug. If have any questions about power line/ device interface/power plug, please contact the
professional people.
11. After installation, please locate a power device in order to disconnect power or connect the power
plug to electrical socket. This electrical socket should be installed to a convenient position. If the
accident occurs during operation, please disconnect power or take out the power plug.
12. The ceiling or wall used for fixture installation must be secure enough; load-bearing requirement
must be 4 times of the screen to prevent the screens from falling.
1. Please read carefully with this instructions before installation to avoid damage to product causing
Warnings: Please prevent screen from wet place to avoid electric or fire dangerous.
Warnings
To prevent from electric
dangerous, please don't
remove the end cap. There
is no need for users to
check the parts inside,
please handle the problems
to professional repairman.
Please notice the non-insulated voltage of the
spare parts to prevent from electric dangerous.
Please operate according to the user manual
with the screen.
B1 B2 B3
CB-MIRC72
CB-MIRC84
CB-MIRC100
CB-MIRC120
CB-MIRC150
CB-MIRC180
CB-MIRC200
CB-MIRC240
CB-MIRC77
CB-MIRC80
CB-MIRC92
CB-MIRC100
CB-MIRC106
CB-MIRC120
CB-MIRC150
CB-MIRC180
CB-MIRC200
72
84
100
120
150
180
200
240
77
80
92
100
106
120
150
180
200
20.0/23.0
24.0/27.2
26.6/30.2
29.3/33.4
35.4/40.2
46.2/51.8
50.5/56.8
59.6/66.8
24.5/27.8
24.7/28.0
27.0/30.5
28.2/32.0
29.2/33.0
31.6/36.0
41.2/46.5
48.5/54.5
52.8/59.5
1463x1097
1707x1280
2032x1524
2438x1829
3048x2286
3658x2743
4064x3048
4877x3658
1705x 959
1771x 996
2037x1146
2214x1245
2347x1320
2657x1494
3321x1868
3985x2241
4428x2491
1847
2131
2456
2862
3472
4147
4553
5366
2129
2151
2461
2638
2771
3081
3750
4474
4917
2158
2161
2155
2160
2607
3064
3369
3979
2160
2157
2157
2156
2161
2155
2409
2782
3032
30
50
50
50
50
80
80
80
50
28
50
50
50
50
50
80
80
50
50
50
50
80
80
80
80
50
50
50
50
50
50
80
80
80
850
670
420
120
80
80
80
80
990
950
800
700
630
450
300
300
300
1913x260x226
2197x260x226
2522x260x226
2928x260x226
3538x260x226
4213x260x226
4619x260x226
5432x260x226
2195x260x226
2217x260x226
2527x260x226
2704x260x226
2837x260x226
3147x260x226
3816x260x226
4540x260x226
4983x260x226