Grandview LF-PH(Concave Perm-Fixed Series) - Manual (Page 5)

6 3
3. Effect Clart
2. Push down PVC stripe along the frame slot,lock down PVC stripe with slot tightly.
Note:
A. PVC stripe has directivity, the side has V slot or arrow direction must face the view area,
as per below diagram.
B. When push down the stripe, press the long side tightly first(press from the middle to the end),
and strain the fabric at the other end,then press the other long side down tightly.
C. The press the short side stripe down tightly by the same way.
D. When finish, if there is wrinkles in the view area, the user can loosen PVC strip and make the
necessary adjustment accordingly.
Installation
1.
below instruction and lay on the frame, and moving the fabric to ensure it is located in the centre
of the frame. (note: When fabric facade face downward,please be careful not to scratch it.) Turn over frame with its back upward, set it on clean desktop or ground, expand fabric per
Push down
PVC strip
Fabric
Frame
Push down and lock tightly
Frame
Fabric
inside of screen
(view area)
inside of screen
(view area)
V slot
V slot
arrow direction
V slot or arrow direction
must face the inside of
screen(view area)
The user can loosen PVC strip along the outside direction of
screen and adjust the flatness of fabric accordingly.
5. When the screen is installed on the installation bars, adjust the orientation of the screen to make sure the hole in the
bracket is aimed at the fixed slot in the bottom installation bar. Fasten the security screw to the hole and fix the screen.
( Figure 16-17 )
4. 14-15 ) Fasten the concave bar brackets to the on-wall top and down installation bar slots. ( Figure
Figure 14 Figure 15
Fix
ed
slo
t
Bracket
Bottom
installation bar
Security screw
Concave frame
Bottom
installation bar
Security screw
Bracket
Concave frame
Figure 16 Figure 17
Figure 7
Concave frame
Back side fabric
Side frame