Grandview Power Synchro Relay - Manual

1 2
3
5
7. The projection screen will automatically lower when the projector is on. It will
automatically retract when the projector is turned off (Figure 7).
On Off
7
4. Ensure the wireless receiver is connected to the screen, press the
receiver programming button by inserting a small plastic stick and the
light will flash repeatedly (Figure 3), Then press the signal programming
button (Figure 4), it means that the programming instructions will be
synced to both devices, the receiver light will stop flashing and stay on
once completed.
4
5. Use the installation strap to fix the Power Synchro Relay to the projector
hanger (if applicable). Connect the included power source output cord into
the projector.
Input Voltage：220V
Voltage Frequency ：50/60Hz
Max Input/output power ：5A
Power Input：UI817
：IEC320
Self-Power：1W
Transmitting Power：2.5mW
M ：FM
T ：868MHz
Power Output
odulation Method
ransmitting Frequency
6
1.Connect power cord of projector to the power source input on the
Power Synchro Relay (Figure 1). 2. Connect the other end of the projector's power cord to the electrical
socket (Figure 2).The indicator light will turn on and stay on.
Power Synchro Relay
Description
Directions
Indicator Light
Singal Programming
Figure 1 Figure 2
Power Level
Setup
Instruction Manual for Power Synchro Relay
Wireless Synchro Receiver (RF to IR)
This product can only be used in Grandview Integrated Motorized Screen with“EXT CTRL”input .
Figure 3
Synchro Power Relay
Ceiling
Projector Hanger
Installation Strap
Projector
Wireless Synchro
Receiver (RF to IR)
Synchro Power Relay
Ceiling
Projector Hanger
Fixation Belt
Projector
Figure 5
Figure 4
Figure 6
Figure 7
Power Level Setup
Projector Power On-Off Button
Guangzhou Grandview Crystal Screen Co., Ltd.
P.O. 511400 Federal Ind. Zone No. 363, Yushan West Road,
Shiqiao, Panyu District, Guangzhou, Guangdong, China
Tel: +8620-8489-9499 Fax: +8620-8480-3343
Website: www.grandviewscreen.com
Grandview Crystal Screen Canada Ltd.
#11- 3751 North Fraser Way, Marine Way Business Centre,
Burnaby, BC, Canada V5J 5G4
Tel: 1-604-412-9777 Fax: 1-604-412-9796
Website: www.grandviewscreen.ca
Power Source
Input
Power Source Output
Installation Strap
6. Turn on the projector, and then please press the power level setup with a
small plastic stick when the LED light of projector turns on. At the time, the
indicator light of Synchro Power Relay will turn on with blue-ray.