GoldenEar SuperSat Series - Manual (Page 6)

GoldenEar Technology ► SuperSat Series Manual
SuperSat Series Owner’s Manual
Attaching Center Channel Feet (SuperSat 3C, 50C & 60C Only)
If you are going to set your SuperSat Center Speaker on a table or bookshelf, install the included Adjustable Center
Stand as follows:
Tools required: #2 Phillips Screwdriver
Small Flat Blade Screwdriver (for adjusting tilt back)
Parts included SuperSat 3C: One Adjustable Foot with Rubber-Tipped Set Screw
One Phillips head screw
One plastic washer
Parts included SuperSat 50C: Two Adjustable Feet with Rubber-Tipped Set Screws
Two Phillips head screws
Parts included SuperSat 60C: Two Adjustable Feet with Rubber-Tipped Set Screws
Two Phillips head screws
Instructions:
1. Carefully lay the SuperSat on its face on a soft padded fl at object, such as a table with a towel or blanket,
taking care not to damage the speaker or grille.
2. Align Center Channel Foot with matching insert(s) as shown in the fi gures below.
3. Insert the screw through the stand and into the inserts on the speaker’s back. On SuperSat 3C (ONLY),
place the plastic washer on the screw after the screw has been inserted through the stand and before the
screw is inserted into the insert in the back of the speaker. The plastic washer should be between the stand
and the back of the speaker if this step has been done correctly (see illustration).
4. Tighten the screw into the insert in the back of the SuperSat, do not over tighten.
5. On SuperSat 50C/60C (ONLY), repeat steps 2, 3 and 4 with the second Adjustable foot.
6. Adjust the height of the rubber-tipped set screw(s) to achieve the desire angle. You can adjust the set
screw from above using the small fl at blade screwdriver. Caution should be exercised to rotate the
speaker’s weight off the tip before adjusting to prevent damaging the rubber tip.
6
SuperSat 3C SuperSat 50C & 60C