Go Power! GP-SW300 - Manual (Page 16)

Pure Sine Wave Inverter
GPSW-150
GPSW-300
___________________________________________________________
16
Problem and Symptoms
Possible
Cause
Solution
No output voltage, red
LED blinking slowly Low input
voltage
Recharge the battery.
Check the connections and
cable.
No output voltage,
previous solutions are not
working
Inverter
switched off
No power to
inverter
Turn the inverter ON.
Check wiring to the inverter.
Car lighter fuse
open
Replace the fuse.
Internal fuse
open Have a qualified service
technician check and replace.
Reverse DC
polarity
Have a qualified service
technician check and replace
fuse.
Observe correct polarity.
No output voltage,
overload indicator ON Short circuit or
wiring error
Check the AC wiring for a
short circuit or improper
polarity (hot and neutral
reversed).
8.0 Maintenance
Clean the exterior of the unit periodically with a damp cloth to prevent
accumulation of dust and dirt and check all connections between the battery and
inverter.
9.0 Disclaimer of Liability & Warranty
Go Power! TM provides the following limited 2 year warranty (“Warranty”) coverage
as applicable to the purchaser (“Purchaser”) of the Go Power! TM branded product
(“Product”) directly from Go Power! TM The following constitutes the terms and
conditions of that limited warranty.
9.1.1 What the Go Power! Warranty Covers and for How Long
Subject to the exclusions and claim procedure set out below, Go Power! TM
warrants for a period of 2 years from the date of purchase at the point-of-sale to
the original end-user customer (“Sale Date”), that the Go Power!
TM Product
provides coverage as follows: