Glow-worm Climapro 1 - Manual (Page 3)

0020140263_00 - 11/11 - Glow-worm - 3 -
INTRODUCTION
1 Product documentation
The instructions are an integral part of the
Climapro
1
RF and must be handed to the user on
completion of the installation in order to comply
with the current regulation.
• Carefully read the manual, to enable safe
installation, use and servicing. No liability
can be accepted in the event of damage
for not complying with the guidance in this
instruction manual.
2 CE Mark
The CE mark indicates that the units described in
this manual are in compliance with the following
directives:
- European Directive Num. 2004-108 of
the European Parliament and the Council
regarding electromagnetic compatibility
- European Directive Num. 2006-95 of the
European Parliament and the Council
regarding low voltage
- Directive regarding telecommunications
equipment ( Directive R & TTE 99/5/ EEC of
the Council of the European Community)
INSTALLER
3 Climapro
1
installation
3.1 List of contents
Climapro
1
programmable room thermostat (x1)
Wall support for the Climapro
1
(*) (x1)
Radio receiver (x1)
AA LR6 "alkaline batteries" (*) (x4)
(*) delivered with the wireless version
3.2 Fixing
3.2.1 Wired room thermostat
3.2.2 Wireless room thermostat
3.2.3 Radio receiver
radio receiver on control box unit
1
2
2
Key
1 Control box unit
2 Radio receiver
• Slide the radio receiver into the notches.
i IMPORTANT:
It is easier to pass the EBUS cable if the
pre-cut part is removed.
INTRODUCTION
EN