EXFO BV10 Performance Endpoint Unit - Manual (Page 17)

Physical Interfaces, LEDs, and Buttons
BV10-100 and BV10-1000 13
RESET and DEFAULT Buttons
RESET and DEFAULT Buttons
The RESET and DEFAULT buttons are recessed on the back of the BV10 to
avoid accidental use.
-
RESET Button
The RESET button is used to reboot the BV10. Press the RESET button once
to reboot the BV10. While rebooting, the BV10 displays a series of
messages if the unit is connected to a console.
The reboot command can also be used to reboot the BV10 (refer to reboot
on page 45).
DEFAULT Button
The DEFAULT button is used to reset the BV10 to the factory default
settings. Press the DEFAULT button once to reset the BV10 to its factory
default settings then the unit reboots by itself.
RESET
DEFAULT