Directed Electronics 4103 - Manual (Page 18)

18 © 2008 Directed Electronics. All rights reserved.
Programming options
Programming options control your system's normal, operational set-up.
Most options do not require additional parts, but some may require ad-
ditional installation labor. This system's programming options are listed
below, with the factory default settings in
bold
:
12
• , 24, or 60 minute run time. your system can be programmed
to allow the vehicle to run for 12, 24, or 60 minutes when remote
started.
3, 6, 9, or
•
12
minute timer mode run time. Your system can be
programmed to allow the vehicle to run for 3, 6, 9, or 12 minutes
when remote started in timer mode. Can be set up to 16 minutes
by your installer.
Comfort closure is a programming option which closes the ve-
•
hicle’s windows after remote locking.
Parking lights
•
flashing
or constant. Your system can be programmed
to either flash or to turn on the parking lights constantly during the
entire remote start operation.
Ignition switch-controlled door-locking
•
on
or off. With this feature
on, the doors will lock 3 seconds after the ignition key is turned on,
and unlock when the ignition key is turned off.
The horn honk confirmations for locking and unlocking can be
•
programmed
on
or off. In order for this feature to be programmed
on, the horn must be connected to the system.