beautypg.com

Valet take-over – Directed Electronics 4103 User Manual

Page 14

background image

14

© 2008 Directed Electronics. All rights reserved.

Note:

If the remote start is on the parking lights will turn off then flash

2-times before returning to their normal output and the defogger output,
if active, will cease.

To turn the rear defogger output ON:

Simultaneously press & release the

1.

+

+

buttons on the

remote control.
The lights will flash 3 times.

2.

The rear defogger output will once again activate when the ve-

3.

hicle is remote started.

Note:

If the remote start is on the lights will turn off then flash 3-times

before returning to their normal output and the defogger output will
activate as programmed.

Valet Take-Over

The Valet Take-Over feature allows the vehicle to remain running after
the key has been removed from the ignition. This feature is useful for
occasions when you wish to exit and lock the vehicle for short periods
of time, but would like to leave the motor running and the climate
controls on.

To perform Valet Take-Over:

Before turning off the engine, press and release

1.

on the trans-

mitter for 1 second.
Turn the ignition key to the OFF position. (The engine will stay

2.

running.)
The vehicle will run for the pre- pro gram med period of time (12,

3.

24, or 60 minutes) or until a shutdown input is trig gered.