ENMET CP-60 User Manual

Page 19

CP-60

ENMET Corporation

5.2.7 Set New Password

To change the password, you must enter the maintenance menu. Press the

OPTION

switch until “Enter Maint Menu” is displayed

then press

SELECT

switch for the Enter Password menu. Enter the valid password as described in Section 5.2.1.

To set a new password, after inserting a valid password,

Press the

OPTION

switch until; "

Set New Password”

is displayed.

Press the

SELECT

switch; "

Password

❚

1270

" is displayed, with the underscore cursor under the left digit.

Use the

OPTION

switch to change the left digit, when the desired digit is displayed.

Press the

SELECT

switch to lock the digit in place and move the cursor one digit to the right.

When all four digits of the new password have been selected, "

Set New Password

" is displayed.

Record the new password; without it, the maintenance menu cannot be reentered once you exit the Maintenance Menu. If the
password is lost, call

ENMET

customer service personnel.

From the "

Password XXXX

" position,

Press the

SELECT

switch to return to Set New Password section.

Press the

OPTION

switch; to continue to "

exit MAINTENANCE Menu

Example: Set Password Flow Chart

5.2.8 Exit Maintenance Menu

From the "

exit MAINTENANCE Menu

" position

Press the

SELECT

switch to resume the operational display.

Press the

OPTION

switch to reenter the maintenance menu at the "

Calibration

" position.

Example: Exit Maintenance Menu Flow Chart

5.3 Channel Activation/Deactivation

Each channel of the

CP-60

can be deactivated and activated as needed.

AUTION

Deactivated channels will not display or respond to connected sensor transmitters.

A fault indication occurs when a transmitter is not connected to an active channel of the

CP-60

To Activate or deactivate a channel of the

CP-60:

Enter the maintenance menu as described in Section 5.2 and press the

OPTION

switch until Exit maint menu appears.

Press and Hold the

OPTION

switch until “

ADV maint menu”

is displayed.

Press the

SELECT

switch to locate the channel to be changed.

Press the

OPTION

switch to change the status of that channel.

Press the

SELECT

switch to accept the change in status. “

ADV maint menu Exit”

is displayed.

Press the

SELECT

switch to return to the operational menu.

MAINTENANCE MENU

Set New Password

Password

❚0000

Changes digit indicated by underscore cursor

Locks underscored digit and moves cursor to next digit

O = Press Option
S = Press Select

MAINTENANCE MENU

Exit maint menu

MAINTENANCE MENU

Calibration

CH-1

CH-3

CH-2

Note:

When in maintenance mode the “_” indicates the location of the cursor, the “

■” block indicates a non-used location.