Elenco FM Wireless Microphone Kit - Manual (Page 9)

-8-
Insert the mic into the slot as shown in Figure F.
Insert the LED into the hole as shown in Figure F.
Place a piece of tape over the LED to hold it in
place.
Insert the PC board into the top case, as shown
in Figure G.
Insert the negative (–) battery clip into the bottom
case as shown in Figure G.
Press the gray antenna wire and the 7” piece of
red wire through the slots in the top case as
shown in Figure G.
Place the bottom case onto the top case. Hold
the two halves together with three 2.6 x 8mm
screws and one 2.5mm x 4mm screw, as shown
in Figure H.
Insert the stand in the case as shown in Figure H.
Push the foam cover onto the case as shown in
Figure H.
Insert two “AA” batteries into the case with the
positive (+) side toward the back end of the case
(see the inscription on the inside of the case).
Caution: Do not mix alkaline, standard (carbon-
zinc), or rechargeable (nickel-cadmium)
batteries. Insert the battery cover onto the case
as shown in Figure H.
FINAL ASSEMBLY
Figure F
Mic LED
Figure H
Foam Cover
2.6 x 8mm Screws
2.6 x 8mm Screws
Battery Cover
Stand
2.5 x 4mm Screw
Figure G
Gray Antenna Wire
Red Wire Black Wire
Bottom Case
Top Case