East Coast Supercharging ECS Half Shaft Loops - Manual (Page 2)

Installation Instructions:
1. Unpack the ECS driveshaft loop kit and check contents.
2. Remove the steel U bends
from the main mounting brack-
ets
3. Mark left and right leaf spring
bolts with a black line. (Fig 1)
4. Loosen leaf spring bolt while
counting the number of turns.
Write the number down. The
leaf spring will lower away
from the control arm making
room for the installation.
5. Apply a few drops of threadlocker to the 7/16 x 2 3/4
bolts.
6. Start one bolt with a lock and flat washer, and lower
mounting bracket into main bracket. ( Fig 2)
7. Slide the bracket assembly into place on the front side
of the control arm between the cross support and the ball
joint. Slide it up from the center towards the front of the
car. (Fig 3)
8. Hold the bracket all the way
forward against the cross sup-
port and start the second 7/16
bolt. You may need to twist the
assembly to get the bolt started
and passed the leaf spring. (Fig
4)
9. Slide the bracket down towards
the ball joint, approximately 1
inch down from the cross sup-
port in the control arm.
Fig 1
Fig 2
Fig 3