EarthQuake 3300V - Manual (Page 7)

OPERATOR INSTRUCTIONS ANd PARTS
Front Tine Models 3300V
Page 7
GetEarthquake.com
800-45-6007
UNPACkING ANd ASSEMBLY
UNPACk TILLER & ASSEMBLE
1. Open top of carton and remove handlebar assembly.
2. Find parts bag (part number 3319). Parts bag for 3300v contains:
2- M8 x 60 bolts
2- hand knobs
1- 10 x 50 clevis pins
6- M5 x 12 bolts
6- M5 nuts
1-depth regulator lever
3. Cut open top of carton and remove machine:
a. Assemble top handlebar over lower loop. Put M8 x 60 bolts
through both holes from inside out. Put on M8 spring wash
ers and tighten with hand knobs.
SEE FIGURE 1.
b. Assemble hood extensions using 6- M5 x 12 bolts plus 6- M5
nuts. SEE FIGURE 2.
c. Assemble tines to unit. Sharp edges of tines will be away
from the operator at top or face down.
At front of machine. Use 2- M10 x 50 clevis pins plus 2- 2.5 x
51.25 hair pins. SEE FIGURE 3.
d. Install wheel assembly to machine using 2- M10 x 20 bolts
with 2-M10 external toothed lock washers. SEE FIGURE 4.
INSTALL dEPTh REGULATOR LEvER
1. Install the depth regulator lever through hole in bracket from the
bottom up with curve to rear of unit and secure with 4 x 94 hair
pin.
SEE FIGURE 6 ON PAGE 9.
FILL ENGINE CRANkCASE
1. Add oil according to engine manual. do not overfill. Use a clean,
high quality detergent oil. Container must be marked A.P.I. Service
SF - SJ. Use no special additives with recommended oils.
do not
mix oil with gasoline. Oil level must be full. Check the oil level
by removing oil fill plug. Oil level should be up to the bottom of the
fill plug opening.
2. Always check oil level before starting engine. Refer to engine
manual for capacity and type of oil to use.
CAUTION !
dO NOT TRY TO LIFT ThE ROTOTILLER FROM ThE
CARTON.
IMPORTANT
ThE RIGhT ANd LEFT SIdES OF YOUR
ROTOTILLER ARE dETERMINEd FROM
ThE OPERATING POSITION AS YOU
FACE ThE dIRECTION OF FORWARd
TRAvEL.
ENGINE IS ShIPPEd FROM FACTORY
WIThOUT OIL. YOU MUST Add ENGINE
OIL BEFORE STARTING ENGINE.
FIGURE 1
FIGURE 2
FIGURE 4 FIGURE