EarthQuake 3300V - Manual (Page 16)

OPERATOR INSTRUCTIONS ANd PARTS
Front Tine Models 3300V
Page 16
GetEarthquake.com
800-45-6007
TROUBLEShOOTING ANd REPAIR
TROUBLEShOOTING GUIdE
While normal care and routine maintenance will extend the life of
your rototiller, prolonged or constant use may eventually require
that service be performed to allow it to continue operating properly.
The troubleshooting guide below lists the most common problems,
causes and remedies.
PRACTICE SAFETY AT ALL TIMES. ENGINE MUST BE
TURNEd OFF ANd ALLOWEd TO COOL, ANd SPARk
PLUG WIRE MUST BE dISCONNECTEd ANd SECUREd
BEFORE ATTEMPTING ANY MAINTENANCE OR
REPAIR.
FAILURE TO COMPLY WITh ThIS SAFETY REQUIREMENT
CAN RESULT IN SERIOUS PERSONAL INjURY TO YOU
OR BYSTANdERS.
WARNING !
PROBLEM REMEdY/ACTION
Engine will not start • Add gas to gas tank.
• Connect spark plug wire to spark plug
• Throttle must be positioned at choke for a cold start
Engine runs rough, floods during operation • Clean or replace air cleaner
Engine is hard to start • Drain old fuel and replace with fresh. Use gas stabilizer
at end of season
• Make sure spark plug wire is securely attached to spark
plug
• Drive safety control lever must be released to neutral
to start the engine
Engine misses or lacks power • Raise the tines for shallow tilling by raising the depth
regulator lever
• Clean or replace air cleaner
• Improper carburetor adjustment, take to authorized
engine service center
• Replace spark plug and adjust gap
• Drain and refill gas tank and carburetor
Engine will not stop when throttle control is positioned at stop • See engine manual to check and adjust throttle linkage
Tiller moves forward during starting
• Drive safety control lever must be released to neutral
to start the engine
Tiller is difficult to control when tilling
(machine jumps or lurches forward) • Lower engine speed in hard ground
• Raise the tines for shallower tilling by lowering the
depth regulator lever
Belts squeal in forward operation • Turn engine off and allow muffler to cool
• Disconnect spark plug wire and secure from spark plug
• Release drive safety control lever to neutral
• Adjust engage cable
• Replace spark plug wire
Excessive heat build up in transmission/tine area during till-
ing • Remove vegetation
• Check transmission fluid and fill if needed