EarthQuake 9060300 User Manual
Page 10
Operator’s Manual
Chipper Shredders
10
Check for parts online at
www.getearthquake.com or call 800-345-6007 M-F 8-5
Attaching Hopper Extension To Hopper
For European models only (14268, 9060140, and 12547)
Tools Required:
•
5/32” Hex drive wrench (i.e: allen wrench)
•
7/16” Wrench for 1/4-20 flange nut
NOTE: Assemble extension before adding fuel or engine
oil.
(1). To attach the hopper extension:
a. Befor
e bolting the handle into position, slide one
hopper extension half (1709470) over the rim of the
hopper. The groove around the inside bottom of the
hopper extension should fit over the rim around the
top of the hopper. SEE FIGURE 4
b. Ensuring the hopper and hopper extension holes are
now aligned along the top rim of the hopper, place
a 1/4-20 x 3/4 bolts (1960507) through each of the
four holes in the extension and hopper. Secure bolts
in place with the included 17/64 x 5/8 flat washers
(1921319) and 1/4-20 flange nuts (1930642). DO NOT
fully tighten hardware at this point. SEE FIGURE 4
c. Bolt handle into position using appropriate hardware.
Lay the unit down, resting the handle on a piece of
cardboard to prevent scratching.
d. Follow Step 1 to install the second extension half to
the opposite side of the hopper. Again, the bottom
groove of the hopper extension should fit over the rim
at the top of the hopper. Align the bolt holes between
the top of the hopper and bottom of the hopper
extension and insert hardware. SEE FIGURE 5
e. Place a 1/4-20 x 3/4 bolt (1960507) in each of the
three holes along the two seams of the joined hopper
extension halves. Secure each bolt with a flat washer
and flange nut. DO NOT fully tighten. SEE FIGURE 6
f. Place bolt through each of the two holes on top of the
joined hopper extension. Secure with flat washer and
flange nut. SEE FIGURE 7
g. Once all hardware has been inserted, use 5/32” allen
wrench and 7/16” wrench to fully tighten all hardware,
including those around hopper rim and along the
hopper extension seams.
FIGURE 4
FIGURE 5
FIGURE 6
FIGURE 7
FLANGE
NUT
FLAT
WASHER
1/4-20 BOLT
HOPPER
EXTENSION
14306-001R1
HOPPER
EXTENSION
1/4-20
BOLT
FLANGE
NUT
FLAT
WASHER
14306-0009R1
1/4-20
BOLTS
14306-0011R1
1/4-20
BOLTS
14306-0012R1