Dynavector P-75 MK3 - Manual (Page 2)

All the above adjustments are easily made by the user. No soldering or extra
components are required.
Standard Settings
When delivered from the factory, the P75 is set to the following standard settings:
Low output moving coil
100 ohm 63dB gain. Shown above.
www.dynavector.com.au
Designed and manufactured in Australia by
Dynavector Amplifiers Australia
P75 mk3 Jumper Location and Settings
Normal (40dB)
High (46dB)
1mV Cartridge
High output MC or Moving Magnet and special 1mV MC
Low output MC ­ standard phono mode
Normal (60dB)
470 Ω 220 Ω 100 Ω 60 Ω 30 Ω
Phono Enhancer mode (Low output MC)
JB 3 & 4 Output level
Set jumpers to suit coil resistance*
Phono Enhancer mode notes
* The coil resistance is obtained from the cartridge manufacturer's specifications.
This resistance is the DC resistance of the coil, sometimes referred to as the
impedance. It is not the cartridge loading resistance.
An example may help:
Dynavector's DV XX2 mkII specification sheet gives the following:
Impedance R = 6 Ω (ohms)
Recommended load resistance >30 Ω. Ignore this in PE Mode.
The DC coil resistance for the DV­XX2 mkII is 6 ohms therefore in PE mode, set
JB3 & 4 for a low resistance coil.
See www.dynavector.com for complete Dynavector cartridge specifications.
For more information visit www.dynavector.com.au
Medium resistance
approx 10­20Ω
Low resistance
approx 4­10Ω
High resistance
approx 20­50Ω
Key blank = no jumper
= fit jumper
= no effect, jumper may be fitted or left off
JB7 & 8 Gain setting
JB3 & 4 Gain setting
High (63dB)
JB1 & 2 Cartridge loading
In appreciation
We wish to express our great appreciation to the late Mr John Bevan
Ford of New Zealand­Aotearoa, contemporary Maori artist and music
devotee, for his generous assistance with the appearance and
functional design of our Dynavector products. While his insight will be
sorely missed, we shall continue to follow his clear guiding principles.
Haere ra John.
© Dynavector Systems Australia Pty Ltd 2012 P75 mk3 manual rev 1.0 PDF version