Display Devices PL-3200 Flat Screen Lifts High Ceiling - Manual (Page 3)

PL3200 PlasmaLift
Programming Show Position
Programming can only be done with three-button control. If other methods of
triggering the lift are normally used, first program the lift with the buttons and then
configure lift for other trigger method.
1.) Press ‘HOME’ button. Unit raises to the home or stored position.
2.) Press and hold ‘STOP’ button for 10 seconds – unit is now in manual mode.
3.) Press ‘SHOW’ button momentarily – unit will travel down. When unit reaches
desired show position press ‘STOP’ button momentarily. THIS MUST BE
DONE IN ONE MOTION, DO NOT PRESS HOME, SHOW, OR STOP FOR FINE
TUNING OF POSITION.
4.) Press and hold ‘STOP’ button for 10 seconds.
5.) Press ‘HOME’ button momentarily – unit will travel to home position.
6.) Lift is now set – press ‘SHOW’ button to verify – unit should travel down to
show position. If you start this procedure and wish to quit after step 2, you
must reset power to lift before normal operation (unplug unit or reset
electrical breaker.