Display Devices PJE Outdoor Projector Enclosures - Manual (Page 2)

Custom Projector Enclosure
8/15/2005
Thank you for purchasing this Display Devices product. Our products are designed to be maintenance-
free, saving you future service time. If you experience any difficulties, please contact us at 303-412-
0399. Thank you for your support.
It is the responsibility of the dealer installer to ensure this product is properly supported and
meets all local building codes. Ensure the ceiling structure is capable of holding at least four
times the combined weight of the enclosure (300 lbs.) and projector (100 lbs). This is a
minimum requirement. Follow any local or state codes that apply to your specific area.
Tools required:
Philips Head Screwdriver
Wire-management tools (stripper/crimper, etc.)
Wrench Set – based upon your mounting hardware
Temperature Control Operation
The Temperature Controller in its basic configuration controls and displays the temperature of the
enclosure.
To start operation, turn on the AC switch on the power supply. The controller will sound an alarm (if
enabled), turn on the air conditioning for 10 to 20 seconds, and then reset the system to a start state.
While operating, the display will show the current temperature and alarm status, if any.
Switched AC Unswitched AC AC input - On/Off Switch