DICE Electronics Universal RDS - Manual (Page 8)

8
UNIVERSAL RDS
Installation
1.Verify compatibility, certain radios require
antenna adapter(s), not included in the kit.
6. Test for 12V constant, 12V switched, and ground sources.
Splice into with leads from power cable.
7. Route kit to glovebox or other accessible location.
8. Connect battery & test*
9. Complete install by re-installing radio
10. Save frequency to a preferred preset on the radio if
desired.
2. Disconnect battery
3. Remove radio from car
5. Install Universal RDS cable. Plug the fac-
tory radio antenna to the receptacle on the
module.
ON
OFF
4. Set the DIP switches for the frequency
selector switch to the desired setting.