Bottom frame assembly – Deltech Fitness HG935- Ultimate Lat Machine User Manual

Page 6

Text mode
Original mode

ATTACH THE FOOT (N) TO THE BOTTOM FRAME (C) USING THE M10 x 76MM
BOLTS (FF), M10 WASHERS (II), AND M10 LOCKNUTS (JJ). INSTALL THE RUBBER
BOOTS (X) OVER THE ENDS OF THE FOOT. NOW INSERT THE 2” SQ. PLASTIC CAP
(S) AND 1 ¾” ROUND CAPS (W) INTO THE BOTTOM FRAME (C).

ASSEMBLE THE 4 ½” PULLEY (Y) INTO THE BOTTOM FRAME (C) USING THE M10 x
43MM BOLT (GG), M10 WASHERS (II), AND M10 LOCKNUT (JJ).

BOTTOM FRAME ASSEMBLY

TOOLS REQUIRED:
METRIC WRENCHES OR SOCKET SET

Some components may be pre-installed
from the factory

(NOTE: THE NUTS USED ON THIS
BENCH ARE LOCK NUTS, THIS MEANS
YOU MUST TIGHTEN THEM DOWN
PAST THE PLASTIC INSERT.)