DaySequerra UpMix - Manual (Page 13)

UpMix User Manual
11
Home Screen
Figure 2. Home Screen on UpMix.
When you power on UpMix, if there are no errors, the display should look similar to the one pictured
above. Each field is dynamic and will show status or current selected settings.
1. Currently selected surround width (Located on SETTINGS menu). May also display current
fault status over fields 1 and 2.
2. Currently selected surround depth (Located on SETTINGS menu). May also display current
fault status over fields 1 and 2.
3. Current clock sync UpMix is operating with. This clock is either internal or externally
acquired.
4. Current output mode. This is selectable on the I/O menu.
5. Input source port will display the port number UpMix is set to receive the audio stream from.
This can be set under the I/O menu.
6. Clock source display will indicate where UpMix is getting a clock signal. This will be
represented as a port number, internal or external.
Programming Menu
If AC line power is lost or momentarily interrupted, UpMix will revert to its previous state.
To enter the programming menu, turn the selection knob in any direction while at the HOME screen.
The ENTER key will enter the currently selected sub menu or enter the value selection mode for the
option. A press of the BACK key will navigate to the previous menu level or revert the current value to
its last stored state.