Danby DBC434A1BSSDD - Manual (Page 8)

6
TOOLS REQUIRED
Phillips #2 screwdriver and an adjustable wrench.
WARNING
Excessive Weight hazard use two or more
people when moving the wine cooler.
Rubber cover
Screws
Decorative cover
Screws
Top Hinge
Decorative nail
Screws
Lower hinge
Cabinet leg
Extrusion-board
of lamp switch
Screws
1
2
3
4
5
6
7
8
9
10
11
1. Close the door and take out rubber cover (1), unscrew two screws (2) and remove decorative cover
(3).(Fig.1).
2. Unscrew screws (4) and take out top hinge (5), then remove the door. (Fig.2)
3. Put the door aside safely and take out two screws (11) at the bottom, pull out extrusion-board of lamp switch
(10) and fix it at top of door. (Fig.5)
4. Pull out decorative nail (6) from left top of cabinet. (Fig.3)
5. Unscrew 3 screws (7) from right bottom of cabinet and remove lower hinge (8). (Fig.4)
6. Pull out cabinet leg (9) from left bottom of cabinet and fix it onto right bottom of cabinet. (Fig.4)
7. Fix the lower hinge (8) onto left bottom of cabinet with screws (7). (Fig.4)
8. The door revolves 180 degrees, put lower door axis to aim at lower hinge (8) and install the door onto lower
hinge (8), then close the door carefully. (Fig.5)
9. Fix top hinge (5) onto left top of cabinet with screws (4), adjust door and install decorative cover (3) and rubber
cover (1). (Fig.6)
10. Block 3 screw holes at right top of cabinet with spare decorative nail.
Installation Instructions
DOOR REVERSAL
INSTRUCTIONS