Danby DBC434A1BSSDD - Manual (Page 11)

Problem Possible Cause What to do
No Power. A fuse in your home may Replace fuse or reset circuit breaker.
be blown or the circuit
breaker tripped.
Power surge. Unplug the beverage centre, wait a
few seconds and then plug it back in.
Plug not fully inserted into Make sure the 3-prong plug on the
wall outlet beverage centre is fully inserted into
outlet.
Cabinet Temperature Temperature setting Verify the temperature control setting.
too High Adjust if neccessary.
Door(s) not shut properly Ensure that the doors are fully closed
or opened excessively and that the gaskets are sealing
against the cabinets. Open the doors
only as needed and for short periods
of time.
Recently added a large Limit the quantity of warm bottles
quantity of warm bottles being introduced to the cabinet at the
to the cabinet same time. Attempt to phase in the
load introduction if possible.
)
“Clicking” Noise Normal sound No user intervention is required as
this sound is normal during the opera-
tion of the appliance. This audible
‘clicking’ noise may be heard as the
appliance ends or begins a cooling
cycle.
Condensation on the High humidity conditions The condensation will subside once
cabinet and/or doors in the home humidity conditions return to normal.
Door(s) not shut properly Ensure that the door is fully closed
or opened excessively and that the gasket is sealing against
the cabinet. Open the door only as
needed and for short periods of time.
Occasionally, a problem may arise that is minor in nature, and a service call may not be necessary. Use this trou-
bleshooting guide for a possible solution. If the unit continues to operate improperly, call an authorized service depot or
Danby’s Toll Free Number 1-800-263-2629 for assistance.
9
Troubleshooting