Da-Lite Curved Multi Format Imager - Manual (Page 10)

10
Multi Format Imager Wiring Diagram
Multi Format Imager Operation
Connect IR eye to splitter for screen operation. IR eye shall be
plugged into a QEYE port on the primary splitter as shown in
Figure 15.
The Multi-Format Imager has been preset to five different formats.
The screen can be set to any format by simply pressing the
corresponding button on the remote. Below is a list of each
button function.
IMPORTANT When operating the switch, press and release the
buttons. DO NOT hold the button for more than five (5) seconds
or the button will be reprogrammed to the current screen
position.
Test installation by carefully running mask surfaces in and out
2-3 times. Be prepared to stop screen. Standard Duty Cycle:
1 MIN.ON./3 MIN.OFF.
CAUTION! Excessive continuos operation may cause
overheating. If motor overheats do not press on remote
and allow motor to cool for 30 minutes.
ATTENTION! Le fonctionnement continu et excessif peut
provoquer une surchauffe. Si le moteur surchauffe,
n'utilisez pas la télécommande et laissez le moteur
refroidir pendant 30 minutes.
4 - Sets format to NTSC (1.33:1)
3 - Sets format to HDTV (1.78:1)
2 - Sets format to Letterbox (1.85:1) format.
1 - Sets format to Cinemascope (2.35:1) format.
OPEN - Sets format to Cinemascope (2.40:1) format.
STOP - Stops the masks at any position when pressed.
<> - Individual control of left and right mask.
Figure 15
IR Eye
Qeye Inputs
6P4C
RJ-14 Cable
Primary Splitter
Secondary Splitter
6P6C
RJ-22 Cable
From Qaux
To Qeye
NOTES:
1.) 6P6C = 6 Pins 6 Conductor Wire
2.) 6P4C = 6 Pins 4 Conductor Wire
RJ-22
RJ-14
Bus (RP Data)
RQ Data
+5V
Ground
White
Green
Red
Black
Green
Bus (RP Data)
+12V
RQ Clock
RQ Data
+5V
Ground
Yellow
Red
Black
White
Blue
STOP
1
3
2
4
OPEN EXT.
PRESET
FORMATS
ADJUST
MASK
RIGHT
LEFT
Figure 16