Dahua Technology LE-A - Manual (Page 51)

51
Figure 4-39
4.9.6 Activate Pattern Function
In
X346H346H346H350H
Figure 4-36
X
, input mode value in the No. blank, and click pattern button.
4.9.7 Auto Scan Setup
In
X347H347H347H351H
Figure 4-35
X
, click border button. The interface is shown as in
X348H348H348H352H
Figure 4-30
X
.
Please go to
X349H349H349H353H
Figure 4-32
X
, use direction arrows to select camera left limit
Then please go to
X350H350H350H354H
Figure 4-40
X
and click left limit button
Repeat the above procedures to set right limit.
Figure 4-40
4.9.8 Activate Auto Scan
In
X351H351H351H355H
Figure 4-36
X
, click “Auto Scan” button, the system begins auto scan. Correspondingly, the auto
scan button becomes Stop button. Click stop button to terminate scan operation.
4.10 Flip
In
X352H352H352H356H
Figure 4-36
X
, click page switch button, you can see an interface is shown as below. See
X353H353H353H357H
Figure
4-41
X
. Here you can set auxiliary function. The aux value has relation ship with the Aux button of
the decoder.
Click page switch button again, system goes back to
X354H354H354H358H
Figure 4-32
X
.
Figure 4-41