Custom Autosound Secretaudio SRMS User Manual

Page 8

INSTALLATION

Before you begin, always disconnect the
battery negative terminal.
Important Notes
• Before final installation, test the wiring
connections to make sure the unit is con-
nected properly and the system works.
• Use only the parts included with the unit
to ensure proper installation. The use of
unauthorized parts can cause malfunctions.
• Consult with your nearest dealer if instal-
lation requires the drilling of holes or other
modifications to your vehicle.
• Install the unit where it does not interfere
with driving and cannot injure passengers if
there is a sudden or emergency stop.
• Avoid installing the unit where it will be
subject to high temperatures from direct
sunlight, hot air, or from a heater, or where
it would be subject to excessive dust, mois-
ture, dirt or vibration.

• This system requires a minimum of 2 speakers (one speaker for

each right and left channel) If you only have a location for one
speaker our DVC (dual voice coil) speaker can be used. Do not con-
nect any of the speaker leads to each other or
vehicle ground.
• System requires 12 volt negative ground.
• Blue power antenna lead is for 12volt
possitve trigger of optional amplifers or power antenna relay. Do not
connect to any accessory that requires high current. If your
vehicle is not equipped with automatic antenna or amplifiers tape
this lead off.
Reset
The reset switch should be activated for the following reasons:
• initial installation of the unit when all wiring is completed
• function buttons do not operate
• error symbol on the display
Use a ball point pin or thin metal object to press the RESET button,
located on the tuner box. You can recover factory default settings
using the RESUME function located on the system menu. With
“YES” flashing, press the SELECT button (4) to activate.

WIRE CONNECTIONS

RESET