ClearCube ClientCube 2 with KM - Manual (Page 10)

Page 10 of 14 P/N G0200161 Rev F, 1.5.01.19.2015
ClearCube Technology, Inc. 3700 W Parmer Lane Austin, TX 78727 (512) 652-3500 www.clearcube.com
Connecting to Physical Devices
Dependencies If you are connecting to physical devices (such as Blade PCs) with PCoIP host cards, use a Web
browser to configure the host card as appropriate for your environment. For more information about
Host Card configuration, see the appropriate zero client Quick Start Guide (included) and PC-over-IP
System User’s Guide (download from ClearCube Support).
Configure zero
clients and
connect NOTE This procedure requires switching mouse modes as described in “ Mouse control:
OSD and VMs ” above .
The table below shows how to connect to physical devices (such as Blade PCs).
Step Action
1 From the keyboard, press CTRL, CTRL, F11, b to set the mouse to relative mode.
You can now use the mouse to configure the zero client or connect to a remote host.
NOTE For information about the OSD and configuration options, see the
documentation cited in “
Package contents and documentation ” and
“ For more information ” on page 1 .
2 From the zero client OSD, click Connect.
If you are using direct connection or reserved DHCP addresses, you are connected to
the remote host specified during configuration. If you are using DHCP and device
discovery, a list of available hosts is displayed. Select a host to connect to. You are now
connected to a remote host.