Clay Paky SHARPY - Manual (Page 21)

SYSTEM VERSION
Used for displaying the software and hardware version of each board
installed in the projector.
CPU brd (CPU board)
0: PT-3f (Pan / Tilt board)
1: 8-Ch (8 channel board)
BOARD DIAGNOSTIC
Used for displaying the status error of each board installed in the projector:
0: PT-3f (Pan / Tilt board)
1: 8-Ch (8 channel board)
DMX MONITOR
Used for displaying the projector DMX channel level in bit (Val) and in
percentage (Perc).
FANS MONITOR
Used for displaying the speed of each fan installed in the projector:
Lamp (Lamp Fan)
Ball. IN (Ballast IN Fan)
PwrSp (Power Supply Fan)
SENSOR STATUS
It lets you check the correct operations of each "sensor” installed in the
projector, each channel is associated with one of the following three
parameters:
• n.a.= sensor not available
• ON= sensor working
• OFF= sensor defective
NETWORK PARAMS
Allows the "Network" parameters of the projector to be displayed or:
IP address: Internet Protocol address (two projectors must not have the
same IP address)
IP mask: 255.0.0.0
Mac address: Media Access Control: the projector’s Ethernet Address
21 SHARPY
LAMP
Used for turning lamp on and off from the projector control panel.
1) Press
F - the current settings appear on the display (On or Off).
2) Use the UP B and DOWN C keys to turn the lamp on (On) or off (Off)
3) Press F to confirm the selection or LEFT D to keep current settings
and return to the top level.
RESET
Used for resetting the projector.
1) Press
F to reset the projectors, a confirmation message (Are you sure
?) appears on the display.
2) Select YES to starting reset the fixture or NO to keep the current setting
and return to the top menu level.
CHANNEL
Used for setting channel levels from the projector control panel.
1) Press
F - the first channel appears on the display.
2) Use the UP B and DOWN C keys to select the required channel:
3) Press F and use the UP B and DOWN C keys to select the
required DMX level (value between 0 and 255).
4) Press LEFT D to return to the top menu level.
MANUAL CONTROL
Lamp
Manual
Control
On
Off
No
Yes
Reset
Sensor
status
Network
params
Channel
Dmx
Monitor
Fans
Monitor
Fan Speed (RPM)
Lamp XXXX
Lamp XXXX
BallIn XXXX
PwrSp XXXX
Information
System
Version Board Revis. Hw.rv.
CPU brd x.x.x x.x
com.dev x.x
0: PT-3f x.x x.x
1: 8-Ch x.x x.x
Board
Diagnost.
Board Status Err%
0:PT-3f Good 0.00
1:8-Ch Good 0.00
Continue ➔