Cino M230B - Manual (Page 8)

Indications
Beeping Indications
No. Beeping Indications Description
1 3 short beeps in ascending tone Power on indication
2 3 short beeps in descending tone Power off indication
3 1 beep at 5 seconds intervals 20%~30% of battery remains
4 2 beeps at 5 seconds intervals 10%~20% of battery remains
5 2 long beeps Error warning
6 1 short beep Radio link built
7 3 short beeps in descending tone Radio link lost
8 1 short beep Press POWER or FEED button
9 1 short beep Close the compartment cover
Battery Status Indications (LED1~LED4)
LED1 LED2 LED3 LED4 Battery Status
Green Green Green Green More than 90% of battery remains
Green Green Green Red More than 70% of battery remains
Green Green Green More than 60% of battery remains
Green Green Red More than 50% of battery remains
Green Green More than 40% of battery remains
Green Red More than 30% of battery remains
Green More than 20% of battery remains
Orange Less than 20% of battery remains
Red Less than 10% of battery remains
a. The Micro2 gives 1 warning beeps at 5 seconds intervals when the battery
power is less than 20%~30%.
b. The Micro2 gives 2 warning beeps at 5 seconds intervals when the battery
power is less than 10%~20%.
c. You may check the battery status by pressing the POWER button.
Wireless Communication Indicator
When Micro2 is ready to be connected or is connected by RS232 interface,
the LED1 will become green, and blinking at two seconds intervals. The
LED5 will go on flash blue when the radio link between the printer and host
device is built. Once the radio link is discontinued, the LED5 will go off and
the LED1 will flash green again.
Battery Charging Indicator
The LED6 will go on steady red after connecting the power supply unit if the
battery hasn’t been fully charged. When the battery is fully charged, the LED6
will go off.
7