Cino M230B - Manual (Page 4)

Loading the Media Roll
The Micro2 is designed to print either receipt or label. Please decide the
printing mode, media type and sensor type before loading the media roll.
Printing Mode
The Micro2 supports both line (default) mode and page mode.
Media Type
Continuous Receipt, I-Mark Media and Gap Label can be applied to Micro2.
Sensor Type
Both Transmissive sensor and Reflective sensor are available for page
ode. m
Loading Media Without Peeler
1.
3
Tear the first label of the media roll. Pull the
backing material out of the printer and lay
across the exit. Assure accurate close of
the media cover by pushing both sides of
the media cover. Press FEED button, the
printer will forward one label and remain
ready in the next printing position.
Push down the media cover knob to
open the media cover.
Make sure the direction of the media roll
is correct. Adjust and insert the media
width adjustment spacer to fit the width of
the media roll, and then load the media.
Push down the media cover knob to
open the media cover.
Make sure the direction of the media roll
is correct. Adjust and insert the media
width adjustment spacer to fit the width
of the media roll, and then load the
media.
Pull the media out of the printer and lay
across the exit. Assure accurate close of
The media compartment cover by pushing
both sides of the media compartment cover.
2.
3.
Loading Media With Peeler
1.
2.
3.