Denon AVR-3808 - Manual (Page 5)

- 5 -
NETWORK SETUP of AVR-3808
>Procedure of Network Setup mode.
(1)Press SYSTEM SETUP button, then System Setup Menu appears on FL-display(and GUI)
(2)Select “Network Setup > Detail” .
(3)Set parameters described below.
"ON"---Use this setting when DHCP server is on the local network.
"OFF"---Use this setting when DHCP server is not on the local network.
When sets "OFF”, please set IP address.
When sets "ON”, you can confirm the IP address that is set by server.
When sets "OFF”, please set Subnet Mask.
When sets "ON”, you can confirm the Subnet Mask that is set by server.
Set the address of Gateway when Gateway is on the local network.
Do not set this parameter when Gateway is not on the local network.
Do not set this parameter.
Do not set this parameter.
Set this parameter "OFF".
(1)Press MENU button, then Menu appears on FL-display (and GUI)
(2)Select “Manual Setup > Network Setup > Other > Power Saving”
(3)Set parameters described below.
“OFF”---Use this setting when using the AVR-3808 connected in a network.
“ON”--- Use this setting when not using the AVR-4308 connected in a network.
This setting is reducing the power consumption in the standby mode.