Bonaire Navigator Controller - Manual (Page 11)

Multi-Appliance Navigator Control
Navigator Control Page 11
Navigating the Controls
10. SIMPLE MANUAL OPERATION
Here's all you have to do to get the system going (If the installer hasn't
already done it for you). To operate the Navigator Controller,
1. Turn the Navigator Controller ON by pressing the ON/OFF button.
2. Press the MODE button to select different modes of operation.
3. Press the or buttons to set the temperature.
Your unit will now operate in manual mode.
NOTE: When the back light is blue, it is in cooling mode.
When the back light is orange, it is in heating mode.
11. APPLIANCE TYPE SELECTION
Your Navigator Controller can operate multiple appliances (where more
than one type of appliance has been connected). You can select your
appliance type by pressing HEAT/COOL button. You will see the Heat,
Cool or Heat/Cool icons on the display of the Navigator Controller.
NOTE: Heat/Cool is only allowed on installations with a heater and
Dual Cycle Refrigerative cooling.
Icon indicates that, your appliance is in heating state.
Icon indicates that, your appliance is in cooling state.
Icon indicates that, your appliance is in heating and cooling state.
To select different appliances,
1. Turn the Navigator Controller ON by pressing the ON/OFF
button.
2. Press the HEAT/COOL button to scroll through the different
appliances if more appliance than one appliance is connected.
3. Press the ENTER button to select your desired appliance type.