Bimba Flat-I Air Cylinder - Manual

Assembly Instructions
Flat-II
General Repair Instructions
K-B-FT-
Bimba Manufacturing Company
Monee, IL 60449-0068
Telephone: 708.534.8544
Fax: 708.235.2014
Email: [email protected]
www.bimba.com
Form: BMS-1023
rev. 1: EC-37763
T o learn more about this
product, scan this QR code
with your mobile device.
Disassembly
1) Using the appropriate allen wrench, remove the 2 bolts from end block.
2) Using the appropriate allen wrench, remove the 4 (8 for long stroke versions) body bolts from the
end caps.
3) Remove the body posts from assembly.
4) Remove the rod guide and rear head from the body.
5) Remove piston/rod assembly from body.
6) For cylinders with Viton option, please skip to step 9.
7) Install provided snap ring into the rod guide (shown in
Figure 1).
8) Press out rear bushings from rod guide.
9) Remove the rod seals from the rod guide. (For cylinders with Viton option, a pick may be
needed.)
10) For cylinders with Viton option, please skip to step 12.
11) Press out rear bushings (as shown in
Figure 2).
12) Remove body seals from rod guide and rear head.
13) Remove the piston seal(s) from the piston/rod assembly.
(see reverse side for reassembly instructions)
END BLOCK BOLT
END BLOCK
REAR HEAD
ROD GUIDE
BODY SEAL
BODY POST
BODY BOLT
BODY
PISTON SEAL(S)
PISTON/ROD ASSEMBLY
BODY SEAL
REAR BUSHING
ROD SEAL
FRONT BUSHING
A A
PIN (NOT SUPPLIED)
ROD GUIDE
SNAP RING FRONT ROD BUSHING
REAR ROD BUSHING
ROD SEAL
FIGURE 1
A A
PIN (NOT SUPPLIED)
FIGURE 2
REAR BUSHING
ROD GUIDE