1 adding/removing/replacing memory – Avalue AID-173SHR User Manual
Page 25
AID-173SHR Quick Reference Guide
AID-173S Quick Reference Guide
25
4.1 Adding/Removing/Replacing Memory
1. Remove the two screws from
the service door.
2. Open the service door.
1. Press the two latches of the
retaining clips locking the
memory module.
2. The memory module will pop
up at an angle.
3. Lift the memory module from
the memory socket.
1. Properly align the memory
module to the connector edge.
2. Slide the memory module into
the memory socket.
3. Push the memory module
down until locked by the clip
latches
4. Close the service door.
5. Lock the service door by
means of two screws.
Note: Please use the correct type of memory on both memory sockets.
See also other documents in the category Avalue Hardware:
- ECM-QM87R (74 pages)
- ECM-BYT2 (71 pages)
- ECM-DX2 (20 pages)
- ECM-BYT (73 pages)
- ECM-KA (24 pages)
- ECM-KA (72 pages)
- ECM-QM77 (24 pages)
- ECM-QM77 (89 pages)
- ECM-CDV (70 pages)
- ECM-CDV (20 pages)
- ECM-QM57 (79 pages)
- ECM-QM57 (24 pages)
- ECM-QB (20 pages)
- ECM-QB (67 pages)
- ECM-PNV (105 pages)
- ECM-PNV (77 pages)
- ECM-PNV (24 pages)
- ECM-VX900 (24 pages)
- ECM-VX900 (74 pages)
- ECM-A50M (24 pages)
- ECM-A50M (77 pages)
- ECM-CX700 (20 pages)
- ECM-LX800W (24 pages)
- ECM-LX800W (105 pages)
- ECM-LX800D (20 pages)
- ECM-LX800D (94 pages)
- ECM-LX800 (24 pages)
- ECM-LX800 (101 pages)
- EPI-QM87 (77 pages)
- EPI-QM77 (24 pages)
- EPI-QM77 (86 pages)
- EPI-QM57 (80 pages)
- EPI-QM57 (20 pages)
- EPI-LX800 (107 pages)
- EPI-LX800 (24 pages)
- EPI-LX800 (20 pages)
- EPI-QM67 (24 pages)
- EPI-QM67 (91 pages)
- EBM-BYT (75 pages)
- EBM-QM87U (75 pages)
- EBM-CDV (82 pages)
- EBM-PNV (24 pages)
- EBM-PNV (79 pages)
- EBM-A50M (79 pages)
- EBM-A50M (24 pages)