Austroflamm Koko Xtra 2.0 - Manual (Page 9)

english 7 Koko Xtra 2.0
Heating in-between seasons
Heating the stove in between seasons, when the outside
temperatures are higher, the flue gases may not be able
to escape completely and this may lead to disturbances in
the chimney draught, especially if the temperatures are
rising suddenly. The stove has to be charged with less
wood and the primary air has to be increased so that the
wood can burn down faster (with visible flames) and thus
the chimney flue can stabilize.
Chimney fire
A Chimney fire may occur, due to sooting and deposits in
the chimney, if improper or humid fuel is used. Close all
air inlets on the fireplace/chimney immediately and call
the fire brigade. Please have an expert inspect your
chimney for cracks and air-tightness after the burning out
of the chimney.
4. THE MOST IMPORTANT SPARES—OVERVIEW
Gaskets
Description Nr.drawing Part number
Flat gasket 8x2, L=1425 mm 5 710096
Door flat gasket 8x2, L=1420 mm 6 710096
Gasket round DM 14x2100 grey 8 714223
Keramott
Description Nr.drawing Part number
Bottom left, Keramott 1 714383
Bottom right, Keramott 2 714382
Rear, Keramott (2 pcs.) 3 714384
Side component left, Keramott 4 714386
Side component right, Keramott 5 714385
Baffle plate rear, Keramott 6 714381
Wood retainer, Keramott 7 714380
Grate 8 716408
Other parts
Description Nr.drawing Part number
Koko 2.0 door 1 719977-29
Door handle 2 719993
Koko 2.0 door spring 3 719996
Koko door glass 4 714442
Glass cleaner ½ litre -- 640070
Stove lacquer -- 650002
Accessories
You can obtain floor plates of glass or steel, fireplace utensils, care products or the Heat Memory System for heat
storage from your certified dealer.
IMPORTANT: Have defective parts replaced by your certified dealer. This will guarantee that your stove
functions properly and safely.
The fireplae must not be attered.
Maintenance
To clean the glass, please use a specialised product such as Thermohit glass cleaner. Lacquered surfaces are to
be cleaned only with a cloth (may be damp). Special cleaning agents should also be used for stainless steel
surfaces. Only gaskets in good order ensure the proper function of your stove!
Cleaning
The stove, flue outlets and smoke pipes should be cleaned and inspected for deposits every year – if necessary
more often, e.g. after the cleaning of the chimney. The chimney also has to be cleaned regularly by the
chimneysweeper. Your chimneysweeper will inform you of the necessary inspection intervals. An expert should
inspect the stove annually.
Keramott numbering = installation instructions!