Dacor EG366 - Manual (Page 2)

Grill Placement and Use
Page 2
Instructions
STEP 1: Before using the grill for the first time, wash it in hot soapy water. Rinse it and allow it to dry
thoroughly.
STEP 2: Make sure all burners are off and the cooktop or range is cool to the touch. Put the grill over the
top of the grates on the cooktop or range in the position shown. The grease trap goes toward the
back. Fit the tabs that stick out of the bottom of the feet into the inside corners of the grate. When
correctly installed, the grill will rest securely about 1/2” above the top surface of the grate. It may
rock back and forth slightly, which is normal.
STEP 3: Set one of the burners under the grill to the light (high) position. Once lit, turn the knob to the
MAX GRIDDLE position, or lower if desired. DO NOT keep the burner knobs higher than the MAX
GRIDDLE setting after they are lit!
STEP 4: Repeat Step 3 for the other burner under the grill.
STEP 5: During cooking be careful with metal utensils on the surface because they can scratch the non-
stick coating. See back for cleaning instructions.
After each use, wash the grill thoroughly in hot soapy water to avoid stains from grease build-up.
The grill is coated with a non-stick coating for easy cleaning. Warm water and liquid detergent are
all that are needed for cleaning. Remove stubborn spots with a non-abrasive plastic mesh pad.
To prevent scratching, do not use abrasives or abrasive cleaners.
Cleaning the Grill
Line up bottom of grill
with top of grate
EG366 and EG486
Grease trap
toward back
Put over center burners