AMT Datasouth Fastmark 4600 PLUS - Manual (Page 6)

P/N 140121 Rev B Page 6/6
Installing Windows Drivers
Windows drivers are included with each
printer
on CD. Run the printer
installation setup, as required for the
version Windows you are using.
Setting Printer Features

Press PAUSE, verify mode on LCD
display.

Press FEED and PAUSE at the
same time to enter setup mode.

Press and hold FEED, use CANCEL
to scroll through the list of features.

Press CANCEL to select desired
feature.

Press and hold FEED, use CANCEL
to scroll through the list of values for
that feature.

Press CANCEL to save the currently
displayed value.

Press PAUSE twice to exit setup
mode and READY the printer.
User Selectable Features
Feature Description
Print Mode
Direct Thermal
Thermal Transfer
Auto Calibrate Mode Mode 1~4
Cut/Peel Offset -015 ~+.050
TPH Vertical Offset -.003~+.003
Recover Print
Enable
Disable
Cutter Installed
Yes
No
Peeler Installed
Yes
No
Counting
Up
Down
Media Sensor Type
Gap
Black Bar
Present Distance 0~040
ABS Darkness 0~030
Trim Darkness -030~+030
Baud Rate
600~1200~2400~4800
~9600~19200~None
Parity (RS232)
None
Even
Odd
Length
7 Data Bits
8 Data Bits
Clear Flash
Yes
No
DHCP
Enable
Disable
NOTE: To manually set Internal Ethernet
addresses, chan
ge DHCP to “DISABLE”.
IP Address ###.###.###.###
Subnet Mask ###.###.###.###
Default Gateway ###.###.###.###
Mac Address ####.####.####
PAUSE
NOTE: Features are subject to change depending on printer model.