Delta ShopMaster 638517-00 - Manual (Page 6)

6
DRILL PRESS PARTS
Fig. 2
1 - Drill Press Head and Motor
2 - Table Raising and Lowering Handle
3 - Table Clamp
4 - Chuck
5 - Chuck Key
6 - Pinon Shaft Handles (3)
7 - M8x1.25x125mm Carriage Head Screws (2), M8 Flat
Washers (2), M8.1 Lock Washers (2), M8x1.25 Hex Nuts
(2) (for fastening the base to a supporting surface)
8 - Worm Gear for Table Raising and Lowering
9 - Allen Wrenches (2)
10 - M8x1.25x25mm Hex Head Cap Screws (4)
11 - Table
12 - Base
13 - Column, Base Flange and Rack
1
2
3
4
6 5
7
8
9 10
11
12
13
A S S E M B LY
A S S E M B LY TOOLS REQUIRED
1.) 2 hex wrenches - supplied 2.) soft-tip hammer
1 hour or less
For your own safety, do not connect the machine to the power source until the machine is
completely assembled and you read and understand the entire instruction manual.
A S S E M B LY TIME E S T I M AT E