Advanced Control Technologies Specs Instructions ZRW153I (RF 120 VAC, 15A, Feed ThroughWall Switch, Three Way, Ivory) - Manual (Page 4)

ZRW153 Instructions, Release 1.1
P/D 103106 HomePro
by ADVANCED CONTROL TECHNOLOGIES, INC.
0706-01
4
Parameter 1). Setting parameter 5 to a value of 0 will cause the ZDW153 to stop ignoring the start level and cause
it to dim based on the command sent.
LED Transmission Indication
• Parameter No: 19
• Length: 1 Byte
• Valid Values = 0, 1 or 2 (default 2)
The ZRW103 will flicker its LED when it is transmitting to any of its 4 groups. This flickering can be set to not flicker
at all (set to 0), to flicker the entire time it is transmitting (set to 1), or to flicker for only 1 second when it begins
transmitting (set to 2). By default, the ZRW103 is set to flicker for only 1 second.
Each Configuration Parameter can be set to its default setting by setting the default bit in the Configuration Set
command. See your controller’s instructions on how to do this (and if it supports it).
All Configuration commands will be reset to their default state when the ZRW153 is reset from the Z-Wave system.
Powerlevel
The ZRW153 supports the Powerlevel command.
The Powerlevel command allows controllers to set and get the RF transmit power level of a node and test specific
links between nodes with specific RF transmit power. Refer to your controller’s instructions, if it supports this
command, for more information. This command is typically used by professional installers.
SUC Support
There must be a Static Update Controller in your Z-Wave system for this feature to work. The Static Controller
can act as a gateway in the system, since other nodes always know its position (not moved after addition to the
network. The “always listening” advantage of the Static Controller is that other nodes can transmit information
frames to it whenever needed.
You can assign an “SUC Route” to the ZRW153. Refer to your controller’s instructions on how to do this (if it
supports it). Assigning an SUC Route to the ZRW153 allows the ZRW153 to request an update of the Z-Wave
devices that are in between it and the Z-Wave device it was trying to transmit to. The ZRW153 will only request
an update when a transmission fails.
SPECIFICATIONS
Power: 120 VAC, 50/60 Hz
Signal (Frequency): 908.42 MHz
Maximum Load - Resistive: 15 amps (1800 watts) maximum, 120 VAC
Motor: 1 H.P. maximum, 120 VAC
Incandescent: 960W maximum, 120 VAC
Range: Up to 100 feet line of sight between the Wireless Controller and /or the closest HomePro
Receiver Module
INTEROPERABILITY WITH Z-WAVE™ DEVICES
A Z-Wave™ network can integrate devices of various classes, and these devices can be made by different
manufacturers. The ZRW153 can be incorporated into existing Z-Wave™ networks.
The top or bottom of the paddle switch on the face of the ZRW153 can be used to carry out inclusion, association,
or exclusion.
WARRANTY
For warranty and general product information visit our web site at www.act-solutions.com