Advanced Control Technologies Specs Instructions ZDW100W (RF 120 VAC, 300W, IncandescentWall Dimmer, White) - Manual (Page 3)

ZDW100 Instructions
090805
HomePro
by ADVANCED CONTROL TECHNOLOGIES, INC.
0618-01
3
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) This device must accept any interference received, including interference that may
cause undesired operation.
FCC NOTICE
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interfer-
ence to radio or television reception, which can be determined by turning the equipment off and on, the user is encour-
aged to try to correct the interference by one or more of the following measures:
- Increase the separation between the equipment and receiver.
- Consult the dealer or an experienced radio/TV technician for help.
IC NOTICE
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device
must accept any interference, including interference that may cause undesired operation of the device.
About ZDW100’s Certification
The ZDW100 has been thoroughly tested by the ETL SEMCO
division of Intertek, a nationally recognized testing laboratory. This
product was found to be in compliance with safety standards
ANSI/UL STD 1472 and CAN/CSA C22.2 No. 184.1.
In addition to compliance with product safety standards, the
ZDW100 is also certified to comply with applicable FCC and IC
rules and regulations governing RF and EMI emissions.
Power 120 VAC, 60 Hz
Signal (Frequency) 908.42 MHz
Maximum Load 300W, for incandescent lamps only
Range Up to 100 feet line of sight between the Wireless Controller and /or the
closest HomePro Receiver Module