ADLINK CSA-5200 - Manual (Page 55)

55
CSA-5200
Stop Bits
Stop bits indicate the end of a serial data packet. (A start bit indicates the beginning).
The standard setting is 1 stop bit. Communication with slow devices may require
more than 1 stop bit. Set this value to 1 and 2.
Flow Control
Set this option to select Flow Control for console redirection.
The settings for this value are None and Hardware RTS/CTS.
VT-UTF8 Combo Key Support
Enable VT-UTF8 Combination Key support for ANSI/VT100 terminals.
The settings for this value are Enabled and Disabled.
Recorder Mode
When this mode is enabled, only text will be sent. This is to capture terminal data.
Set this value to Enabled/Disabled.
Resolution 100x31
Set this option to extended terminal resolution. Set this value to Enabled/Disabled.
Legacy OS Redirection
On Legacy OS, the number of rows and columns support redirection. Set this value
to 80x24, 80x25.
Putty KeyPad
Select function key and keypad on putty. Set this value to VT100, LINUX,
XTERMR6, SCO, ESCN, VT400
.
Redirection After BIOS POST
The settings specify if BootLoader is selected then legacy console redirection is
disabled before booting to legacy OS. Default value is Always Enable which means
legacy console redirection is enabled for legacy OS. Set this value to Always
Enable, BootLoader
.