ADLINK AmITX-BT-I - Manual (Page 17)

AmITX-BT-I Page 17
4. Connectors and Jumpers
See 3.1 Connector Locations on page 13 for connector locations.
4.1. Rear IO Connectors
4.1.1. DC Power Inlet
The AmITX-BT-I supports a screw-type external 12V DC-in power connector. Maximum current draw is 10A.
Note: Either the DC Power Inlet or the internal ATX Power Connector (ATX_PWR) must be used to supply the motherboard with +12V ±5%.
JACK1
PWR-JACK_P1
VCC
1
GND1
2
GND2
3
Caution:
Hot-plugging the power supply is not supported. Doing so may damage the board.
Only connect ONE power supply to the board. Connecting power to both the 12V
DC-inlet and the internal ATX Power Connector may damage the board.