ADLINK IMB-S90 - Manual (Page 33)

Driver Installation 21
IMB-S90
3 Driver Installation
This chapter provides information on how to install the IMB-S90
device drivers under Windows 7 64-bit. The device drivers are
located in the following ADLINK All-in-One CD directories:
Follow the instructions below to install the required IMB-S90 driv-
ers:
1. Install the Windows operating system before installing any
driver. Most standard I/O device drivers are installed during
Windows installation.
2. Install the Display driver by opening device manager. Navigate
to the INF located in X:\IMB-S90\Graphics\v098_whql
\Windows_WDDM\Win7_S08R2_x64. Follow the instructions
given and reboot when instructed.
3. Install the Chipset driver by running the program Setup.exe
in X:\IMB-S90\Intel INF\infinst_autol for XXX (where XXX is
Sandy Bridge or Ivy Bridge). Follow the instructions given and
reboot when instructed.
4. Install the Ethernet driver by running the program Auto-
run.exe in
X:\IMB-S90\LAN\513189_Release_17_4_OEM_Gene_2843
34_split. Follow the instructions given and reboot if required.
5. Install the Marvel RAID driver by opening device manager. Nav-
igate to the driver located in X:\IMB-S90\Marvell\PSP2.3.0.1046
\windows\Driver\1.2.0.1032-WHQL\storport\amd64. Follow
the instructions given and reboot if required.
Display X:\IMB-S90\Graphics
Chipset X:\IMB-S90\Intel INF
Ethernet X:\IMB-S90\LAN
Rapid Storage X:\IMB-S90\Intel RST
RAID X:\IMB-S90\Marvell