ADLINK Express-LPC - Manual (Page 56)

Express-LPC User’s Manual Page 56
Serial Port Mode
Select the baud rate you want the serial port to use for console redirection. The options are
115200 8,n,1; 57600 8,n,1; 19200 8,n,1; and 09600 8,n,1.
Flow Control
Set this option to select Flow Control for console redirection. The settings for this value are None,
Hardware, or Software.
Redirection After BIOS POST
This option allows you to set Redirection configuration after BIOS POST. The settings for this
value are Disabled, Boot Loader, or Always.
Option Description
Disabled Set this value to turn off the redirection after POST
Boot Loader Set this value to allow the redirection to be active during POST and Boot Loader.
Always
Set this value to allow the redirection to be always active.
Terminal Type
This option is used to select either VT100/VT-UTF8 or ANSI terminal type. The settings for this
value are ANSI, VT100, or VT-UTF8.
VT-UTF8 Combo Key Support
This option enables VT-UTF8 Combination Key Support for ANSI/VT100 terminals. The settings
for this value are Enabled or Disabled.
Sredir Memory Display Delay
This option gives the delay in seconds to display memory information. The options for this value
are No Delay, Delay 1 Sec, Delay 2 Sec, or Delay 4 Sec.