ADLINK cExpress-BT - Manual (Page 35)

cExpress-BT Page 35
4.4. XDP Debug Header
The debug port is a connection into a target-system environment that provides access to JTAG, run control, system control,
and observation resources. The XDP target system connector is a Molex 26-pin 52435-2671 connector. Specific plating types,
locking clips, and alignment pin details of this connector can be obtained from Molex. No specific plating types, locking clips
or alignment pins are required for the XDP tool.
Pin XDP Signal Target Signal I/O Device Pin XDP Signal Target Signal I/O Device
1 OBSFN_A0 TAP_PREQ# I/O SoC 2 OBSFN_A1 TAP_PRDY# I/O SoC
3 GND GND NA 4 OBSDATA_A[0] DBG[0] I/O SoC
5 OBSDATA_A[1] DBG[1] I/O SoC 6 GND GND NA
7 OBSDATA_A[2] DBG[2] I/O SoC 8 OBSDATA_A[3] DBG[3] I/O SoC
9 GND GND NA 10 HOOK0 PMC_RSMRST# I SoC
11 HOOK1 PMIC_PWRBTN# O System 12 HOOK2 PMC_CORE_PW ROK I SoC
13 HOOK3 ILB_RTC_TEST# O SoC 14 HOOK4 Open NA
15 HOOK5 Open NA 16 VCCOBS_AB 1.8VS (SUS) I System
17 HOOK6 PMC_PLTRST# I SoC 18 HOOK7 PMC_RSTBTN# O SoC
19 GND GND NA 20 TDO TAP_TDO I SoC
21 TRSTn TAP_TRST# O SoC 22 TDI TAP_TDI O SoC
23 TMS TAP_TMS O SoC 24 TCK1 Open NA
25 GND GND NA 26 TCK0 TAP_TCK O SoC
Refer to the "Bay Trail M/D/I Platform” Debug Port Design Guide (DPDG), Document Number: 512816, Revision: 2.1
4.5. Fan Connector
¾ Connector Type: JVE 24W1125A-04M00
¾ Pin Orientation:
1 2 3 4
¾ Pin Definitions:
Pin Signal
1 FAN_PWMOUT
2 FAN_TACHIN
3 Ground
4 5V